GAS GAS MC 125 2022, Руководство пользователя

Страница: 51 / 131

SERVICE WORK ON THE CHASSIS 11
49
–
Using a plastic hammer, tap lightly on the upper triple clamp to
avoid stresses.
–
Tighten screws
1
.
Guideline
Screw, top triple clamp M8 20 Nm (14.8 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, top steer-
ing stem M8 20 Nm (14.8 lbf ft)
Loctite ® 243™
Finishing work
–
Check steering head bearing play. ( p. 48)
–
Remove the motorcycle from the lift stand. ( p. 42)
–
Mount the handlebar cushion.
11.13 Lubricating the steering head bearing
H02387-01
–
Remove the lower triple clamp. ( p. 45)
–
Install the lower triple clamp. ( p. 46)
Info
The steering head bearing is cleaned and lubricated in the
course of removal and installation.
11.14 Removing the start number plate
S04535-10
–
Remove screw
1
.
–
Disconnect the brake line at the start number plate. Take off the
start number plate.
11.15 Installing the start number plate
S04536-10
–
Connect the brake line at the start number plate.
–
Position the start number plate.
The holding lugs engage in the fender.
–
Mount and tighten screw
1
.