SERVICE WORK ON THE ENGINE 16
103
16.2
Checking the gear oil level
Info
The gear oil level must be checked when the engine is cold.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
S04567-10
Main work
–
Remove gear oil level monitoring screw
1
.
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
Add the gear oil.
–
Mount and tighten the gear oil level monitoring screw.
Guideline
Screw, gear oil level
monitoring
M6
8 Nm (5.9 lbf ft)
16.3
Changing the gear oil
Warning
Danger of scalding
Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
Drain the gear oil while the engine is at operating temperature.
Preparatory work
–
Park the motorcycle on a level surface.
–
Position an appropriate container under the engine.
Содержание MC 125 2022
Страница 1: ...OWNER S MANUAL 2022 MC 125 Art no 3215051en...
Страница 2: ......
Страница 131: ...3215051en 3215051en 06 2021 Stallhofnerstra e 3 5230 Mattighofen Austria http www gasgas com...