4
PRODUCT MANUAL
SANVITO
1.
Introduction
Thank you very much for purchasing a Garz & Fricke product. Our products are dedicated to professional use
and therefore we suppose extended technical knowledge and practice in working with such products.
The information in this manual is subject to technical changes, particularly as a result of
continuous product upgrades. Thus this manual only reflects the technical status of the
products at the time of printing. Before design-in the device into your or your customer’s
product, please verify that this document and the therein described specification is the latest
revision and matches to the PCB version. We highly recommend contacting our technical sales
team prior to any activity of that kind.
Please also verify all herein described specifiations carefully before transfering them to your
own documentation for the end-product to ensure their validity for your installation conditions.
The attached documentation does not entail any guarantee on the part of Garz & Fricke GmbH
with respect to technical processes described in the manual or any product characteristics set
out in the manual. We do not accept any liability for any printing errors or other inaccuracies in
the manual unless it can be proven that we are aware of such errors or inaccuracies or that we
are unaware of these as a result of gross negligence and
Garz & Fricke has failed to eliminate these errors or inaccuracies for this reason.
Garz & Fricke GmbH expressly informs that this manual only contains a general description of
technical processes and instructions which may not be applicable in every individual case. In
cases of doubt, please contact our technical sales team.
In no event, Garz & Fricke is liable for any direct, indirect, special, incidental or consequential
damages arising out of use or resulting from non-compliancy of therein conditions and
precautions, even if advised of the possibility of such damages.
Distribution of this document to third parties is prohibited.
Before using a device covered by this document, please carefully read the applied master
supply agreement.
Embedded systems are complex and sensitive electronic products. Please act carefully and
ensure that only qualified personnel will handle and use the device at the stage of development.
In the event of damage to the device caused by failure to observe the hints in this manual
and on the device (especially the safety instructions), Garz & Fricke shall not be required to
honour the warranty even during the warranty period and shall be exempted from the statutory
accident liability obligation. Attempting to repair or modify the product also voids all warranty
claims.
