Garmin Xero S1, Руководство пользователя

Страница: 5 / 14

Getting Started
WARNING
This device is intended to provide accurate aiming solutions
based on calibrated measurements of current conditions only.
Depending on your environment, conditions may change rapidly.
Changes in environmental conditions, like wind gusts or
downrange winds, may have an effect on the accuracy of your
shot. Aiming solutions are suggestions only based upon your
input into the device. Always allow a margin of safety for
changing conditions and reading errors.
Always inspect your equipment before using a firearm. You are
responsible for understanding and complying with any
applicable regulations for using a firearm.
Always understand your target and what lies beyond your target
before taking a shot. Failure to account for your shooting
environment could cause property damage, injury, or death.
See the
Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The Xero S1 Trapshooting Trainer helps you improve your
trapshooting score by tracking a clay target and your shot using
a combination of sensors. The device can track orange, green,
and pink clays in both 108 mm and 110 mm sizes. Other sizes
and colors are not supported.
NOTE: This device is intended to track one clay and one shot at
a time. Doubles trap and trap games that allow multiple shots
are not supported.
Device Overview
Power button
Press to turn on the device.
Hold to turn off the device.
Micro-USB power and
data port (under weather
cap)
Connect a compatible USB cable to charge
the device or transfer data using your
computer.
Touchscreen
Swipe to scroll through features, data
screens, and menus.
Tap to select.
Protective cover
Remove before using the device.
Replace when not in use.
Tripod Adjustments
The tripod adjustment controls are located on the underside of
the Xero S1 device.
Tripod adjustment
button
Adjusts the angle of the Xero S1 device on
the tripod ball mount
Tripod release lever
Opens the socket to install or remove the
tripod ball mount
Installing the Tripod
1
Screw the tripod ball mount onto the tripod assembly .
NOTE: You should tighten the tripod ball mount so it does not
move during use. The tripod ball mount uses 1/4"-20 thread
size and is compatible with most tripods. For best
performance, do not raise the device beyond waist height or
a total height of 1.2 m (4 ft.).
2 Completely depress and hold the tripod release lever .
Getting Started 1