STRIKER
™
PLUS 4 ICE FISHING
BUNDLE
INSTALLATION
INSTRUCTIONS
Important Safety Information
WARNING
See the
Important Safety and Product Information
guide in the
chartplotter or fishfinder product box for product warnings and
other important information.
To obtain best performance and to avoid possible damage, you
must install this mount using these instructions.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation, go
for more information.
Battery Warnings
WARNING
The Garmin
®
device uses a user-replaceable, sealed, lead-acid
battery. If these guidelines are not followed, the battery may
experience a shortened life span or may present a risk of
damage to the device, fire, chemical burn, electrolyte leak,
and/or bodily injury.
• Do not place the battery near objects that may cause sparks,
flames, or heat.
• Do not incinerate the battery.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open
battery. Avoid contact with internal acid. Contact with internal
acid may cause irritation or severe burns. Irritation may occur
to the eyes, respiratory system, and skin. Flush with water at
once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
• Keep the battery away from children.
• Only replace the battery with the correct replacement battery.
Using another battery presents a risk of fire or explosion of
the device or charger.
• Only charge the battery with the included charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in a
high-temperature location, such as in the sun in an
unattended vehicle. To prevent damage, remove the device
from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than
recommended chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of
the battery in accordance with applicable local laws and
regulations.
• When storing the battery for an extended time, store within
the following temperature range: from 5° F to 104°F (from
-15° C to 40° C).
• Do not operate the battery outside of the following
temperature range: from 5° F to 122° F (from -15° C to 50°
C).
Assembling the Portable Mount
You need a Phillips screwdriver to assemble the portable mount.
1
Insert the handle into the two openings on the portable
mount .
2
Secure the handle to the portable mount using the two
included M4×0.7×40 mm screws and nuts .
3
Orient the swivel-mount base on the portable mount with
the opening facing away from the battery compartment.
4
Fasten the swivel-mount base using the three M4×0.7×10
mm screws .
5
Slide the swivel mount into the opening on the swivel mount
base until it locks in place.
6
Snap the cradle into the swivel mount.
7
Snap the device in the cradle until it locks in place.
Connecting and Stowing the Cables
CAUTION
Ensure that you connect the correct spade connector to the
correct battery terminal. Damage to the battery or device, or
bodily harm may occur if the device is improperly connected to
the battery.
1
Identify the power cable and transducer cable and the
corresponding ports on the device.
2
Align the divot on each connector to the keying on each
device port.
3
Push the cable connectors into the correct port until the
connector is fully seated.
TA-2018/168
GUID-167DD16E-7EA7-4EA0-AE94-6C485787B031 v1
July 2020
