Garmin Panoptix Livescope, Руководство по установке

Страница: 2 / 6

Installing the Transducer on a Trolling Motor
NOTICE
You must secure the transducer cable to the shaft or other
secure location during installation. Damage to the transducer
cable wires or cable jacket can cause transducer failure.
1 Insert the hose clamp
À
through the slot on the trolling motor
mount
Á
until equal lengths extend on both sides of the
mount.
2
Secure the hose clamp around the trolling motor
Â
.
NOTE: Do not rotate the transducer.
3
Secure the transducer cable to the motor shaft or other
secure location.
4 Route the transducer cable to the installation location of the
sonar module while taking these precautions.
• You should not route the cable close to electrical wires or
other sources of electrical interference.
• You must route the cable so it is not pinched when the
trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length you can connect
an optional extension cable, available at buy.garmin.com or
from your Garmin dealer.
5 Position the transducer to your desired angle ( Trolling Motor
Mount Orientation , page 2 ).
Trolling Motor Mount Orientation
The orientation depends on which side of the trolling motor you
have mounted the transducer on, and your desired field of view.
TIP: No tools are necessary to change the orientation from
forward to down. Turn the mount one click to change the
orientation from forward to down.
À
Starboard side, forward view
Á
Starboard side, downward view
Â
Port side, forward view
Ã
Port side, downward view
Installing the Transducer on a Trolling Motor
Shaft
Trolling Motor Shaft Bracket Orientation
The trolling motor shaft bracket features an 8-degree cant to
reduce the effects of the trolling motor barrel interference with
the transducer beam. You must orient the arrow
À
and the
narrow end of the angle
Á
to the top when you attach the
bracket to the trolling motor shaft.
Assembling the Trolling Motor Shaft Mount Hardware
With the trolling motor bracket oriented correctly ( Trolling
Motor Shaft Bracket Orientation , page 2 ), use the included
hex wrench to attach the transducer
À
to the trolling shaft
bracket
Á
with the shoulder screw
Â
, flat washer
Ã
, and
rubber washer
Ä
.
NOTE: You must fully tighten the mount to the transducer.
The recommended torque applied to the shoulder screw is
2.5 lb-ft. (3.4 N-m).
Installing the Transducer on the Trolling Motor Shaft
NOTICE
You must secure the transducer cable to the shaft or other
secure location during installation. Damage to the transducer
cable wire or the cable jacket can cause transducer failure.
You should mount the transducer as far from the motor as
possible.
You should use the included rubber insert on a 25 mm (1 in.)
trolling motor shaft.
1
Using the included hex wrench, insert the M6 screws
À
and
attach the shaft trolling bracket
Á
to the transducer bracket
Â
around the trolling motor shaft.
2