58
nüvi 3400 Series Owner’s Manual
Changing the Fuse in the Vehicle
Power Cable
noTICE
When replacing the fuse, do not lose any of the
small pieces and make sure they are put back in
the proper position. The vehicle power cable
does not work unless it is assembled correctly.
If your device does not charge in your vehicle,
you may need to replace the fuse located at the
tip of the vehicle adapter.
1
Unscrew the end piece.
TIP
: You may need to
use a coin to remove the
end piece.
2
Remove the end piece,
the silver tip, and the
fuse (glass and silver
cylinder).
3
Install an 2 A fast-blow fuse.
4
Place the silver tip in the end piece.
5
Screw the end piece back into the vehicle
power cable.
Mounting on Your Dashboard
noTICE
The permanent mounting adhesive is extremely
difficult to remove after it is installed.
Use the enclosed mounting disk to mount your
device to the dashboard and comply with certain
state regulations.
1
Clean and dry the dashboard where you are
placing the disk.
2
Remove the backing from the adhesive on
the bottom of the disk.
3
Place the disk on the dashboard.
4
Remove the clear plastic cover from the top
of the disk.
End
piece
Silver tip
Fuse