DUAL-POLARIZATION AirCell™ ANTENNA INSTALLATION MANUAL
Page 5
P/N 190-00189-12
Rev. A
The outline and footprint dimensions for the antenna and doubler plate are shown in Figures 3 and 4,
respectively, on page 6.
1.
Using the doubler plate as a template, mark the location of the mounting holes and the through
hole for coaxial cable. Drill or punch the holes.
2.
Use the doubler plate (part of 013-00059-00 kit) as required for thin-skinned aircraft.
3.
The antenna installation must provide adequate support for the antenna. Observe guidelines for
acceptable installation practices as outlined in AC 43.13-2A.
4.
Fasten antenna to aircraft with six (6) #8-32 screws, lockwashers, and locknuts (parts of
013-00059-00 kit)
5.
The “N Type” ground connector on the Low Profile Antenna is not used and should be capped
with the plastic cover supplied with the antenna.
3.5. CABLE INSTALLATION
1.
Route the coaxial cable to the NavTalk Pilot Adapter mounting location keeping in mind the
recommendations of Section 2. Secure the cable in accordance with good aviation practice.
2.
Trim the coaxial cable to the desired length and install the TNC connector per the cabling
instructions on Figure 2. If the connector is provided by the installer, follow the connector
manufacturer’s instructions for cable preparation.
Figure 2. Coaxial Cable Installation
