190-01499-02
GTX 3X5 Transponder TSO Installation Manual
Rev. 4
Page 4-12
4.7.3
Vertical Remote Mount Units
NOTE
The Bluetooth antenna in the GTX 345 is at the front of the unit and must point to the
passenger area to provide the best Bluetooth connection. Bluetooth performance from a
remote unit can be limited due to obstructions in the aircraft. In this situation, better
performance can be obtained by using a Flight Stream 110/210.
The GTX 3X5 vertical remote mount base is installed in the vertical orientation with six #10-32 100° flat-
head screws and locking nuts. Refer to figure B-6 for mounting hole spacing dimensions. The base may
also be used as a template to mark or drill the mounting holes.
Point the wedge-shaped end of the vertical remote mount shoe to the back of the unit. Attach the vertical
remote mount shoe to the unit with the four screws provided. Torque
the
screws to 15-16 in-lbs.
Attach the connectors and optional GAE, if used, to the connector backplate the same way as panel mount
units. Refer to section 4.7.1.
4.7.4
GX000 Integrated Flight Decks
The GTX 3X5 G1000 rack is mounted to the main system rack with the nutplate kit listed in section 3.4.2.
At least eight screws are required to secure the rack as shown in figure B-7. Refer to
G1000 System
Installation Manual
. Attach the connectors and optional GAE, if used, to the connector backplate the same
way as panel mount units. Refer to section
4.8
Panel and Standard Remote Mount Unit Installation and Removal
CAUTION
The application of hex drive tool torque more than 8 in-lbs can damage the locking
mechanism.
NOTE
When a unit is installed make sure it successfully powers up. Refer to section 6 for
configuration procedures.
NOTE
Before placing the unit in the rack, in order to make sure the position of the retention
mechanism is correct, it can be necessary to insert the hex drive tool into the access hole
and turn the hex drive tool counterclockwise until it fully stops.
Insertion
1. Slide unit in until it stops, approximately 3/8 inch short of the final position.
2. Insert a 3/32" hex drive tool into the access hole at the bottom of the unit face.
3. Push on the left side of the bezel and turn hex drive tool clockwise and apply 8 in-lbs of torque.
Removal
1. Insert the hex drive tool into the access hole on the unit face.
2. Turn hex drive tool counterclockwise until the hex drive tool stops.
3. Pull the unit from the rack.