Garmin GNS 530W, Руководство и справочник пилота

Страница: 189 / 230

9 - AUX PAGES
179
Setup 1 Page
field. Use the small and large right knobs
to enter the desired buffer distance. Press
ENT
when finished.
This buffer distance is added to the floor/
ceiling limits and provides an added margin
of safety.
NOTE:
When an approach has been loaded into
the active flight plan, airspace alert messages are
disabled within 31 NM of the destination airport.
To change the maximum CDI scale setting:
1. Select “CDI / Alarms” from the Setup Page.
2. The flashing cursor highlights the “Selected
CDI” field. Turn the small right knob to select
the desired CDI scale. The selected scale and
any lower scale settings are used during the
various phases of flight as described in Section
11 FDE - CDI/Alarms.
3. Press ENT to accept the selected scale. The
“System CDI” field displays the CDI scale cur-
rently in use. The “System CDI” setting may
differ from the “Selected CDI” depending upon
the current phase of flight.
NOTE: The CDI scale is always displayed in nautical
miles, regardless of the current distance units of mea-
sure selected on the Units / Position Page.
To change the ILS CDI selection:
1. Select “CDI / Alarms” from the Setup Page.
2. Turn the
large right
knob to highlight the
“ILS CDI Capture” field.
3. Turn the
small right
knob to select “Auto” or
“Manual”, as desired. Press ENT to accept the
selection.
NOTE: Installations with certain autopilots, such as the
KAP 140 and KFC225, do not allow automatic ILS CDI
switching.
“Auto” ILS CDI Capture switches the CDI
output from GPS to the VLOC receiver as you
intercept the final approach course.