Garmin GCV 10, Инструкция по установке

Страница: 2 / 4

2
Connect the bare-wire end of the power cable to a 12 Vdc
power source and to ground.
3
Align the notch on the end of the power cable with the power
port on the device, and press the cable into place.
4
Tighten the locking ring.
5
Repeat steps 3 and 4 for the network and transducer cables.
Installation Diagram
You can use this diagram to identify the connection points from
your sounder to the network, power, and transducer.
Item Description
À
Chartplotter
Á
GCV 10
Â
Power Source
Ã
Transducer
Cable Routing Grommets
NOTICE
Cable routing grommets do not create a waterproof seal. To
create a waterproof seal, apply a marine sealant around the
grommet and cable after installation. Be sure to test the system
before sealing the grommets.
When routing cables through your boat, it may be necessary to
drill holes to route the connector ends of the cables. A rubber
grommet is provided to cover the cable hole for a finished look.
You can purchase additional grommets from your Garmin
dealer or directly from Garmin at www.garmin.com .
Installing the Cable Grommet
1
Mark the location where you want to route the cable.
2
Using a 32 mm (1¼ in.) paddle drill bit or hole saw, drill the
installation hole.
3
Route the cable through the hole to the sounder.
4
Spread the grommet apart at the split, and place it around
the cable.
5
Firmly push the grommet into the installation hole until it is
seated.
6
Apply marine sealant, as needed, to weatherproof the
installation hole.
Blink Codes
After the sounder is installed, it turns on when the chartplotter is
turned on. The two-color (green and red) LED on the sounder
indicates its operational status.
LED
Color State Status
Green Slow blink The sounder is connected to a chartplotter
and is operating properly. You should see
sonar data on the chartplotter.
Red Slow blink The sounder is turned on, but is not
connected to a chartplotter, or is waiting to
connect to a chartplotter. If the sounder is
connected to the chartplotter and this code
persists, check the wiring connections.
Red/
Green Slow blink The sounder is in test mode.
Red Rapid blink
sequence System error. The chartplotter displays a
message indicating the type of failure. When
the error condition is fixed, the sounder must
be completely disconnected from and
reconnected to its power source to clear the
error.
Specifications
Specification Measurement
Size (H×W×D) 251 x 192 x 66 mm (9.9 x 7.6 x 2.6 in.)
Weight 845 g (1.86 lb.)
Case Material Fully gasketed, polycarbonate plastic, water
resistant to IEC 60529-IPX7
Temperature Range From -15° to 70°C (from 5° to 158°F)
Power Input From 10 to 35 Vdc
Power usage 10.5 W maximum
Fuse 4.0 A, mini 42 Vdc, fast-acting, blade-type
Compass Safe
Distance 260 mm (10.2 in. )
Transmit Power (RMS)* 500 W per element (1,500 W combined)
*dependent upon transducer rating and depth
Frequency 455/800 kHz
Depth** 229 m (750 ft) down; 153 m (500 ft) side
**maximum depth, dependent upon
transducer, water salinity, bottom type, and
other water conditions
Data Output Garmin Marine Network
2