Garmin G1000 NXi, Дополнительное руководство по обслуживанию, Страница: 150 / 171

G1000 Supplemental Maintenance Manual Page 7-45
Textron Nav III Series Revision 3
190-02128-04
Legacy Replacement Procedure GSA81 Servos (Alternate Method)
1. Insert the software loader card in the top slot of the PFD.
2. Power on the MFD and PFD in configuration mode.
3.
Select no when “Do you want to update system files” is displayed on the screen of the
PFD.
4. S
elect the “
SYSTEM UPLOAD
” page using the small FMS knob on the PFD.
5. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate
the large FMS knob to highlight
“0X – XXX”
(where 0X is the menu position and XXX is
the airframe type) and press ENT key on the PFD.
6. Rotate the small FMS knob to display the drop down menu. Rotate the large FMS knob
highlight
“Option – GFC 700 Installation”
. Press ENT key on the PFD.
7. Press the CLR ALL key.
8. Scroll to highlight the installed servo.
9. Highlight the software box and press the ENT key to check the box.
10. Scroll to highlight the installed servo cert line.
11. Highlight the software box and press the ENT key to check the box.
12. Press the Load softkey.
13. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green “PASS” in the Configuration and Software columns for each item loaded.
•
“Upload Complete………….COMPLETE” in the summary box.
14. Press ENT key on the PFD to acknowledge upload complete.
15. Deactivate cursor.
16. Scroll to the Configuration Manager page.
17. Press the CNFM CFG softkey.
18. Se
lect ok when prompted to “Confirm configuration as expected configuration”
19. Power cycle the system verify there are no red-Xs or system alerts.
20. If red-Xs or system alerts are present, troubleshoot as necessary using Section 5.
21. If there are no red-Xs or system alerts, continue to return to service checks in Section 9.