Garmin G1000 Diamond DA62, Руководство пилота

Страница: 72 / 630

Garmin G1000 Pilot’s Guide for the Diamond DA62
190-01895-00 Rev. A 58
FLIGHT INSTRUMENTS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
TURN RATE INDICATOR
The Turn Rate Indicator is located directly above the rotating compass card. Tick marks to the left and right
of the lubber line denote half-standard and standard turn rates. A magenta Turn Rate Trend Vector shows the
current turn rate. The end of the trend vector gives the heading predicted in 6 seconds, based on the present
turn rate. A standard-rate turn is shown on the indicator by the trend vector stopping at the standard turn
rate tick mark, corresponding to a predicted heading of 18˚ from the current heading. At rates greater than 4
deg/sec, an arrowhead appears at the end of the magenta trend vector and the prediction is no longer valid.
Arrow Shown
for Turn Rate
> 4 deg/sec
Half-standard
Turn Rate
Standard
Turn Rate
Figure 2-19 Turn Rate Indicator and Trend Vector
BEARING POINTERS AND INFORMATION WINDOWS
Two bearing pointers and associated information can be displayed on the HSI for NAV, GPS, and ADF
sources by pressing the PFD Softkey then a BRG or DME Softkey. The bearing pointers are cyan and are
single-line (BRG1) or double-line (BRG2). A pointer symbol is shown in the information windows to indicate
the navigation source. The bearing pointers never override the CDI and are visually separated from the CDI
by a white ring. Bearing pointers may be selected but not necessarily visible due to data unavailability.
Figure 2-20 HSI with Bearing and Distance Information
Bearing 1
Pointer
Bearing 2
Pointer
Bearing 2 Information Window
ADF
Frequency
Pointer 2 Bearing Source
Bearing 1 Information Window
Bearing Source Pointer 1
Distance to
Bearing Source
Station
Identifier
Frequency
Tuning Mode
Distance