190-01895-00 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA62
116
AUDIO PANEL AND CNS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
4.4 GTX 33/GTX 33 ES MODE S TRANSPONDER
The GTX 33 Mode S Transponder provides Mode A, Mode C, and Mode S interrogation and reply capabilities.
Selective addressing or Mode Select (Mode S) capability includes the following features:
• Level-2 reply data link capability (used to exchange information between aircraft and ATC facilities)
• Surveillance identifier capability
• Flight ID (Flight Identification) reporting – The Mode S Transponder reports aircraft identification as either the
aircraft registration or a unique Flight ID.
• Altitude reporting
• Airborne status determination
• Transponder capability reporting
• Mode S Enhanced Surveillance (EHS) requirements
• Acquisition squitter – Acquisition squitter, or short squitter, is the transponder 24-bit identification address.
The transmission is sent periodically, regardless of the presence of interrogations. The purpose of acquisition
squitter is to enable Mode S ground stations and aircraft equipped with a Traffic Avoidance System (TAS) to
recognize the presence of Mode S-equipped aircraft for selective interrogation.
• Extended squitter – If equipped with an extended squitter, the extended squitter is transmitted periodically
and contains information such as altitude (barometric and GPS), GPS position, and aircraft identification.
The purpose of extended squitter is to provide aircraft position and identification to ADS-B Ground-Based
Transceivers (GBTs) and other aircraft.
The Hazard Avoidance Section provides more details on traffic avoidance systems.
TRANSPONDER CONTROLS
Transponder function is displayed on three levels of softkeys on the PFD: Top-level, Mode Selection, and
Code Selection. When the top-level
XPDR
Softkey is pressed, the Mode Selection softkeys appear:
STBY
,
ON
,
ALT
,
GND, VFR
,
CODE
,
IDENT
,
ADS-B TX, BACK
.
When the
CODE
Softkey is pressed, the number softkeys appear:
0
,
1
,
2
,
3
,
4
,
5
,
6
,
7
,
IDENT
,
BKSP
,
BACK
. The digits 8 and 9 are not used for code entry. Pressing the numbered softkeys in sequence enters the
transponder code. If an error is made, the code selection cursor can be moved back to the left one digit with
each press of the
BKSP
Softkey.
Pressing the
BACK
Softkey during code selection reverts to the Mode Selection Softkeys. Pressing the
BACK
Softkey during mode selection reverts to the top-level softkeys.
The code can also be entered with the
FMS
Knob on the PFD. Code entry must be completed with either the
softkeys or the
FMS
Knob, but not a combination of both.
Pressing the
IDENT
Softkey while in Mode or Code Selection initiates the ident function and reverts to the
top-level softkeys.
After 45 seconds of transponder softkey inactivity, the system reverts back to the top-level softkeys.
Содержание G1000 Diamond DA62
Страница 2: ......
Страница 14: ...Garmin G1000 Pilot s Guide for the Diamond DA62 190 01895 00 Rev A x TABLE OF CONTENTS Blank Page...
Страница 629: ......