Disconnecting the Cables in the Shaft Cap
Before you can disconnect the cables in the shaft cap, you must open the shaft cap (
).
1 Unscrew and disconnect the USB connector .
Ensure the o-ring remains in place inside the connector.
2 Release the latch and pull the connectors apart to disconnect the data cable.
3 Unscrew and disconnect the transducer cable .
4 Carefully cut off the transducer cable locking ring.
5 Carefully cut off the zip ties .
6 Slide down the protective coverings on the power cables.
7 Using a 2.5 mm allen wrench, remove the four set screws on the two power cables.
8 Disconnect the power cables.
9 Remove the protective coverings from the power cables.
4