10
Fishfinder 90/140 Owner’s Manual
Installing Your Fishfinder
OK
Level
Drill pilot holes here.
Vertical
Bottom of the transom
Align with the
transom bottom. The
transducer should
extend 1/8" below
fiberglass hulls or
3/8" below aluminum
hulls.
Keep it parallel with the water line.
Installing the Fishfinder Unit
Selecting a Fishfinder installation Location
Select a Fishfinder installation location that allows you to
view and operate it easily while operating the vessel. Select
a mounting surface strong enough to support the weight
of the Fishfinder and protect it from excessive vibration or
shock. DO NOT mount the bracket in a location where the
Fishfinder is exposed to extreme temperature conditions.
When installing the mounting bracket, be sure to allow
room to connect and rout the power cable.
Mounting the Bracket Assembly
Tool List (not included)
—drill, screwdriver (Phillips or
standard), three #8 pan-head machine bolts with matching
nuts and washers, and a 5/32" drill bit; or three #8 pan-head,
self-tapping screws and a 1/16" drill bit.
190-00582-10_0A.indd 10
12/2/2011 3:08:58 PM
