2
Use the 2.5 mm hex key to remove the screw
À
from the
handlebar connector
Á
.
3
Place a rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
4
Place the handlebar connector around the rubber pad.
NOTE:
You should align the contours on the rubber pad with
the grooves on the inside of the handlebar connector.
5
Replace the screw, and use the 2.5 mm hex key to tighten
the screw.
NOTE:
Garmin recommends tightening the screw so the
mount is secure, with a maximum torque specification of
7 lbf-in. (0.8 N-m). You should check the tightness of the
screw periodically.
6
Insert the battery pack into the bottom of the mount.
The lever
Â
must be in the open position. The red mark
indicates the open position.
7
Snap the lever to the closed position to lock the battery pack
into the mount.
8
Insert the Edge device into the top of the mount.
The lever
Ã
must be in the open position. The red mark
indicates the open position.
9
Snap the lever to the closed position to lock the Edge device
into the mount.
10
If necessary, use a USB cable to connect the Edge device to
the output power USB-A port on the battery pack (
).
Device Information
Specifications
Battery type
Lithium-ion battery
Output capacity
3100 mAh at 5 V (15.5 Wh)
Battery operation time
Up to 24 hr. powering the Edge 1030 device
Charging temperature
range
From 0º to 45°C (from 32º to 113°F)
Operating and storage
temperature range
From -20º to 60ºC (from -4º to 140ºF)
Input
5 to 5.5 V, 2 A
Output
Electrical contacts: 5.07 V, up to 1 A
USB port: 5.07 V, up to 2.4 A
Water rating
IEC 60529 IPX7*
*The device withstands incidental exposure to water of up to 1 m
for up to 30 min. For more information, go to
.
Limited Warranty
The Garmin standard limited warranty applies to this accessory.
www.garmin.com/support/warranty
Installation Instructions
3