Setting Range Alerts
If you have an optional heart rate monitor, cadence sensor, or power meter, you can set up range alerts. A range
alert notifies you when the device measurement is above or below a specified range of values. For example, you
can set the device to alert you when your cadence is below 40 RPM and over 90 RPM. You can also use a
training zone for the range alert (
).
1 Select
> Activity Profiles.
2 Select a profile.
3 Select Alerts and Prompts.
4 Select Heart Rate Alert, Cadence Alert, or Power Alert.
5 Select the minimum and maximum values, or select zones.
Each time you exceed or drop below the specified range, a message appears. The device also beeps if audible
tones are turned on (
Turning the Device Tones On and Off, page 42
).
Setting Recurring Alerts
A recurring alert notifies you each time the device records a specified value or interval. For example, you can set
the device to alert you every 30 minutes.
1 Select
> Activity Profiles.
2 Select a profile.
3 Select Alerts and Prompts.
4 Select an alert type.
5 Turn on the alert.
6 Enter a value.
7 Select
.
Each time you reach the alert value, a message appears. The device also beeps if audible tones are turned on
(
Turning the Device Tones On and Off, page 42
).
Auto Lap
®
Marking Laps by Position
You can use the Auto Lap feature to mark the lap at a specific position automatically. This feature is helpful for
comparing your performance over different parts of a ride (for example, a long climb or training sprints). During
courses, you can use the By Position option to trigger laps at all of the lap positions saved in the course.
1 Select
> Activity Profiles.
2 Select a profile.
3 Select Alerts and Prompts > Lap.
4 Turn on the Auto Lap alert.
5 Select Auto Lap Trigger > By Position.
6 Select Lap At.
7 Select an option:
• Select Lap Press Only to trigger the lap counter each time you press
and each time you pass any of
those locations again.
• Select Start and Lap to trigger the lap counter at the GPS location where you press
and at any location
during the ride where you press
.
• Select Mark and Lap to trigger the lap counter at a specific GPS location marked before the ride and at
any location during the ride where you press
.
8 If necessary, customize the lap data fields (
).
38
Customizing Your Device
