GPSMAP
®
66i Powered Mount
Installation Instructions
Important Safety Information
WARNING
See the
Important Safety and Product Information
guide in the
GPS device product box for product warnings and other
important information.
Installing the Device in the Mount
NOTICE
Before you place the device in the mount, ensure the metal
contacts on the device and the mount are dry. Moisture on the
contacts causes equipment damage. Use the weather cap to
keep the mount dry.
1
Place the weather cap in the storage area on the mount.
2
Align the mounting spine with the notches on the mount, and
slide the device down until it snaps into place.
Removing the Device from the Mount
1
Press the tab on the mount to release the device.
2
Lift the device out of the mount.
3
Place the weather cap on the metal contacts.
Connecting Power to the Mount
1
Select a mounting location based on available power sources
and an unobstructed view of your surroundings.
2
Route the USB cable, and connect it to a power source.
Attaching an AMPS Base Plate to the Mount
NOTE:
The base plate is not included with all powered mounts.
1
Thread the screws through the washers , mount , and
base plate .
2
Tighten the nuts to secure the base plate.
NOTE:
The recommended torque is 1.7 to 2.25 N-m (15 to
20 lbf-in.).
Mounting the Device in an Automobile
1
Clean and dry your windshield and the suction cup with a lint-
free cloth.
2
Press the suction cup to the windshield, and flip the lever
back toward the windshield.
3
Align the ball of the suction cup mount and the ball of the
base plate with the double-socket arm .
4
Tighten the knob slightly.
2
Installation Instructions
