Packet Broker
EdgeLens Inline Security Packet Broker | INT40G2XR44 | 1.19.5
4.1 Filter Template
Filter templates may be created as a pass-all, pass-by, or deny-by. Pass by or deny by templates may
include multiple matching options to filter traffic. The options are considered by the system as (and)
options. Thus, for traffic to pass it must match all defined options. Once a template is created it will
appear on the Create Config Map panel and may be used to create an ingress filter. Template options
may be modified when applied to a config map. Any option modification made will not change the original
template. It is advisable to rename a filter applied to a config map if the original template options were
modified.
1. Select Filter Templates on the Packet Broker Configurations panel. The Filter Templates panel will be
displayed.
2. Select Create Template. The Create New Filter Template panel will be displayed.
3. Enter the template name. If no name is entered the system will automatically apply a name as follows,
tmplt, tmplt(2), tmplt(3), etc.
4. Enter the description, optional.
5. Select the Template Type, Pass All, Pass By or Deny By.
6. If pass by or deny by was selected in Step 5, the options will be displayed as follows.
Source MAC Address / Source MAC Mask
Destination MAC Address / Destination MAC Mask
Ether Type
Source IP Address / Source IP Mask
Destination IP Address / Destination IP Mask
Inner VLAN ID
Outer VLAN ID
DSCP
IP Protocol
L4 Source Port or Range
L4 Destination Port or Range
7. Select Save Template once all desired option modifications have been completed.
8. The new filter template will appear on the Filter Templates panel.
9. The filter template may be modified by selecting the template name.
10. The filter template may be deleted by selecting the red X.
Garland Technology | 716.242.8500 | garlandtechnology.com/support
Copyright © 2022 Garland Technology, LLC. All rights reserved.
21
