USER GUIDE
EdgeSafe 40G Bypass Modular Network TAP | M40GBP
Version 1.6 Page 29 of 159
Garland Technology reserves the right to make changes without further notice to any products or data herein to improve reliability, function or design.
Confidential -This document is
Garland Technology
.'s property. This document may not be copied, duplicated and transferred to electronic or mechanized
media or used for any other purpose, including any part thereof or attachment thereto, except as authorized in advance and in writing by
Garland Technology.
5.4 Connecting the RS232 DB9 management cable
1.
Connect the RS232 DB9 cable supplied with the EDGESAFE 40G to the M40GBP
2.
Connect the other side of the RS232 cable to your Appliance RS232 port.
3.
Use any terminal emulation software (Minicom, HyperTerminal …) to connect to the CLI
interface to in order manage the M40GBP.
4.
Set the following terminal communication parameters:
115200 – default or 9600 if set by CLI command
8 bits
no parity
1 stop bit
no flow control
5.
Power on the M40GBP
6.
Login prompt will appear in terminal window.
7.
The login name: customer, the default password: Garland Technology
8.
After login you should change password, user and date. If you plan to use management
Ethernet port, set IP address, net mask and gateway parameters.
5.5 Connecting the Ethernet management port
1.
Connect Ethernet cable (CAT5) to the
Management 1G Ethernet network port
2.
Use any Telnet or SSH client to connect to the CLI interface in order to manage the M40GBP
3.
The following are the default IP and login parameters
IP address: 10.10.10.200
Net mask: 255.255.255.0
Gateway: 10.10.10.200
Login name: admin
Password: gtadmin1
4.
The following are default snmp user/community name and password (for snmp 3 and
)
user/community name: admin
password: gtadmin1