Operation
40
115051
6.
8
.4
Menu item: „Factory settings“
Designation
Explanation
Software
WELCH-Control 521
Control panel
at the controller
FU motor
not settable
analog output active
calibration allowed
not settable
= present
= not present
read
not settable
Reading the set values
Confirmation of acceptance by signal tone
send
not settable
Transmission of changed values to the controller
Confirmation of acceptance by signal tone
CAUTION !
These settings are adapted by the manufacturer to match the supplied configuration.
The user can change the settings after inputting the password
(“File” menu item).
