Gardenpro KCR26RC-BS, Руководство пользователя

Страница: 58 / 69

58
A safety switch trips when the driver sat down.
30) Ignition key.
31) Blade rotation engagement lever.
32) Parking brake lever.
33) Drink holder.
34) Drive and speed change engagement lever
The lever selects:
- the four forward gears;
- the neutral position (N) ;
- the reverse gear (R).
35) Rear driving wheels
36) Engine compartment door - must be raised to
fill up with petrol and oil.
2.4. MACHINE ASSEMBLY
2.4.1 FITTING THE STEERING WHEEL
Position the machine on the flat and align the front
wheels.
5) Fit the steering wheel shaft extension on the shaft
and secure it with the screw and the nut provided
(fig.5). Tighten well.
6) Fit the steering seat on the shaft and secure it with
screws provided (fig.6). Tighten well.
INSTRUCTION MANUAL
7) Fit the steering seat casing to the shaft and secure
it with screws provided (fig.7). Tighten well.
8) Position the steering wheel on the extension and
secure with the screws and nuts provided (fig.8).
Tighten well. Then stick the label on the steering
wheel.
2.4.2 FITTING THE SEAT
3) Fit the seat on the deck, with the screws (fig. 9 A)
and nuts (fig.9 B). Tighten well and make sure the
seat can rotate smoothly.
4) To adjust the seat position, first loosen the screws
(fig.10 C), then take apart the plastic nut (fig.10 A),
and move the seat to appropriate hole (fig.10 B).
Tighten the plastic nut and screws.
2.4.3 FITTING THE GRASS
COLLECTION BAG
9) Find out screws as described in fig.11.
10) Pre-assemble the main bag frame according to
fig.12 and fig.13.
11) Tighten all screws and the nuts after the frame is
finalized (fig.14).
12) Fit the frame inside the bag, and secure all the
plastic profiles (fig.15) to the frame tubes, with the aid
of a screwdriver.
13) Fasten the upper cover of bag to the bag frame,
using the screws provided.
14) Fit the bag handles in the cover (fig.16).
15) Secure the bag (fig.18) to the machine (fig.17),
according to fig.19: Grasp the handles by two hands,
connect the bag into left and right plate, and slip the U
steel into grooves of the plates.
16) Warning: the lawnmower shall not be operated
without the entire grass bag in place.
2.4.4 FITTING THE BATTERY
HAZARD: Never throw the battery away
into the environment. If the battery has to
be changed, following the disposal
procedures laid down by local authorities.
3) Raise the seat then you can see the battery under
the seat (fig. 20).
4) Detach the battery cover, and rotate tight the
battery wires. Red wire for “+” polarity and black for “-”
polarity (fig. 21).