24. Low-voltage cable
25. Operator’s Manual and Quick Guide
2.3 Symbols on the product
These symbols can be found on the product. Study them
carefully.
WARNING: Read the user
instructions before operating
the product.
WARNING: Disable the prod-
uct before working on or lift-
ing the product.
WARNING: Keep a safe dis-
tance from the product when
operating. Keep your hands
and feet away from the rotat-
ing blades.
WARNING: Do not ride on
the product. Do not put your
hands or feet close to or un-
der the product.
Use a detachable power sup-
ply as defined on the rating
plate next to the symbol.
This product complies with the applicable
EU Directives.
This product complies with the applicable
UK Directives.
It is not permitted to dispose this product
as normal household waste. Ensure that
the product is recycled in accordance with
local legal requirements.
The low-voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low-
voltage cable. Be careful when trimming
edges where the cables are placed.
2.4 Symbols on the battery
WARNING: Lithium-ion batteries can
explode or cause fire if disassembled,
short-circuited or handled roughly. Do not
expose to water, fire or high temperature.
Read the user instructions.
Do not discard the battery into fire and do
not expose the battery to a heat source.
Do not immerse the battery into water.
2.5 General manual instructions
The following system is used in the Operator’s Manual
to make it easier to use:
•
Text written in
italics
is a text that is shown in the
display or is a reference to another section in the
Operator’s Manual.
•
Text written in bold is one of the buttons on the
product.
2.6 Keypad
Use the keypad on the product to select an operating
mode for the product. Push the button for 1 second or
3 seconds to set an operating mode, refer to
. The buttons on the keypad with
flashing lights are the available operating modes for the
product that you can select. You must enter the PIN
code for the product before you can select an operating
mode.
•
Use the ON/OFF button (A) to switch on and
switch off the product.
•
Use the Park button (B) to send the product to the
charging station.
•
Use the OK button (C) to confirm the settings you
select in the menus.
•
Use the Start/Schedule button (D) to start the
product and set a schedule. The schedule will start
at this current time each day and the product will
operate to its maximum cutting time each day.
•
Use the Start button (E) to start the operation of
the product.
8 - Introduction
1585 - 007 - 26.10.2022
