RTxxx LED controllers -User Manual
9.10
Viewing the trigger status
47
9.11
Viewing the output current
47
10
Ethernet communication(RT220, RT420, RT820F)
49
10.1
Connection
49
10.2
IP Address
49
10.2.1
DHCP
50
10.2.2
Fixed IP address
50
10.3
Automatic sensing
50
11
Webpage configuration (RT220, RT420, RT820F)
52
11.1
Main page
52
11.2
Configuration page
53
11.3
General setup page
54
12
Command configuration
55
12.1
Ethernet configuration(RT220, RT420, RT820F)
55
12.2
RS232 configuration(RT260, RT460, RT860F)
55
12.3
Command structure
55
12.3.1
General commands
56
12.3.2
Lighting channel commands
59
12.3.3
Command summary
61
13
Reference information
62
13.1
Specification
62
13.2
Restrictions
63
13.3
Error codes
64
13.4
Fatal error codes
65
13.5
Event codes
65
RTxxx LED lighting controllers - User Manual
1
Getting started
This user manual describes the setting up and operation of the RTxxx
range of LED lighting controllers.
Read Section Safety (or
Section 3, Sicherheit
, or
Section 4, Sécurité
) and
Section 13.1, Specification
, and check the RTxx controller fulfils your
requirements.
Mount the RTxxx as described in
Section 5, Mounting the RTxxx
and
connect the RTxxx up to a power supply as described in
Section 6,
Connections
. The RT200 shows a two alternating lines on it's display to
indicate it is working properly.
Read
Section 8, Lighting setup
. Enter the current or voltage rating of the
lights and then connect the lights. Set up the RTxxx for the desired
operation as described in the configuration sections;
Section 9, Front
panel configuration (RT200)
,
Section 11, Webpage configuration (RT220,
RT420, RT820F)
, and
Section 12, Command configuration
.
Visit
www.gardasoft.com
for application notes on this product. There is
also a Support page which has information on troubleshooting problems.
1.1
Summary of features
Throughout this manual, references to the RTxxx refer to all variants in the
RTxxx range unless otherwise stated. The convention for the product
number is:
RTcd0-vv
RTcd0F-vv
where:
c
Number of channels: 2, 4, 8
d
Configuration option: 0 = Pushbutton, 2 = Ethernet,
6 = RS232
F
Option for fast pulsing. All RT8xx models are fast
pulsing.
vv
Maximum pulse current in amps: 2, 20
—
5
—
WWW.STEMMER-IMAGING.COM