RTxxx LED lighting controllers - User Manual
9
Front panel configuration (RT200)
Using the front panel keypad, you can set the configuration for each
channel, set a keylock code so unauthorised users cannot change any
settings, set the internal trigger time, view trigger status, and set the
voltage or current rating.
9.1
Startup
On power up, the RT200 displays
b
for five seconds followed by
8
.
8
.
8
.
to
show that the display is working, then
RT2
and
00
, followed by the
firmware version (for example
039
). The controller is then ready for
operation.
When the RT200 is not being configured the display indicates the status of
both channels as shown below:
The RT200 displays an error if a light is connected but no rating has been
specified. See
Section 9.2, Setting the light rating
.
To configure the RT200 from the front panel, press and hold
SEL
for 1
second.
CH1
is displayed. You can then use the
p
and
q
keys to scroll
through the menu, pressing the
SEL
button to access the required set up
as shown in the table below:
Display
Select to:
CH1
Set up output channel 1
CH2
Set up output channel 2
LOC
Set up a key lock
FrE
Set up the internal trigger
—
30
—
RTxxx LED lighting controllers - User Manual
Display
Select to:
trg
View the trigger status
UAL
View the output current
rAt
Set the lighting rating
During the setup of a channel, the trigger can be set to active high or low
according to the
P
flag setting. Error checking can be enabled or disabled
using the
E
flag.
9.2
Setting the light rating
Press and hold
SEL
for one second ,
CH1
is displayed. Use the
p
and
q
buttons to scroll to
rAt
and follow the keystrokes below:
rAt
is displayed. Press the
SEL
button.
Use the
p
and
q
buttons to select the channel
you want to set the rating for, and press the
SEL
button.
Cur
is displayed. Press the
SEL
button if your
light is current rated.
Or...
—
31
—
WWW.STEMMER-IMAGING.COM