RC1xx - User Manual
2
Safety precautions
Read this before using the RC1xx. Always observe the following safety
precautions. If in doubt, contact Gardasoft Vision Ltd. The following
symbols are used in this guide:
Warning:
Read the instructions to understand the
possible hazards.
Warning:
Surface may get hot.
Where these symbols appear in this guide, refer to the text for the
precautions you should take.
2.1
Heat
Ensure the RC1xx is mounted correctly (see
), and that you do not exceed any of the ratings for the unit (see
Section 11.1, Specifications and ratings
).
At its maximum ratings, the RC1xx’s enclosure can exceed 65°C which is
sufficient to cause a burn if touched. Place in a position where personnel
cannot accidentally touch it and ensure there is a free flow of air around
the unit.
2.2
Electrical
The RC1xx produces high energy pulses. Take care to connect the
outputs correctly and protect the output wiring and load from any short-
circuits. When switched off, energy remains stored in the RC1xx for about
15 seconds.
The RC1xx does not have complete tracking isolation of input and output.
Transients caused by inductive loads must be supressed externally to the
RC1xx.
Warning:
This is a Class A product. Its use in residential areas may cause
radio interference, and such use should be avoided unless special
measures are taken by the user to restrict emissions to a level that allows
the reception of broadcast transmissions.
2.3
General
The RC1xx must not be used in an application where its failure could be a
danger to personal health or damage to other equipment.
If the equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
—
2
—