GARANT G-ELS Series, Руководство пользователя

Страница: 46 / 132

46
DE
EN
FR
IT
ES
7.1 Swing doors and sliding doors
(Product group 92 – 95, 97, 98)
Doors with locking rods: Start from step 1
Doors without locking rods: Start from step 2.1
Step 3:
You can now remove the lock unit from the outside.
Pull the mechanical lock unit off the door towards the outside.
Step 4:
Insert the electronic lock unit with the slides into the installation aperture.
The cover plate now lies on the door panel.
Step 1:
Using side cutters, pull the two clamping discs a
and b on the interior of the door off the bolts.
Remove the locking rods.
a
b
Step 2.1:
Press the two clamping brackets together from above and below...
Step 2.2:
... and at the same time push the lock unit to the left as far as the stop in
the panel cut-out. This applies to right-hand closing doors
(for left-hand closing doors = the installation situation is turned through 180°).
Step 5.1:
Push the lock unit to the left into the installation aperture and...
Step 5.2:
... press the lock body to the right straight into the door panel. The small lug on
the right in the door panel is fed in this way into the rear groove of the lock body.
Step 5.3:
Move the handle in the direction of insertion in the installation aperture until
it locks into place (type of bayonet lock).
5.1 5.2 5.3
Step 6:
The cover plate of the lock unit is positioned firmly against the door panel.
Your electronic lock unit is now ready for use.
Step 7: (For doors with locking rods only)
Position the locking rods on the inside of the door back on the bolts and
fasten them with the clamping discs.
7. Installation in GARANT storage cabinets