Garage Smart myLIFTER, Инструкция по установке и эксплуатации

Страница: 20 / 31

Part 4: Install the Hook and Pulley
NOTICE
The basic MyLifter unit can lift up to 50 pounds without using the eyelet
screw and pulley system. If your item weighs more than 50 pounds you
must install the eyelet screw and run the cable under the pulley in the
hook.
To install the hook and pulley, you need to lower the cable from the lifter. To lower the
cable, you need to use the MyLifter app and pair the lifter with your smart device.
1. Download and install the MyLifter app from
or the .
2. Ensure that the Bluetooth features are enabled on your smart device.
3. In the MyLifter app, tap
Add Devices in the bottom right corner to open the Avail-
able Lifters screen.
This screen displays a list of all lifters within range of your Bluetooth com-
munications. If you do not see any available lifters, make sure you have plugged
in the power cable to the nearest outlet.
On the MyLifter unit, you should see a slow blinking yellow Status light.
4. Firmly press the Pair button next to the Status light on the lifters.