76
77
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
Access
Simply click on Faults. The IIDTool will automatically proceed with scanning all ECUs to detect the
presence of faults. Following the scan, you can either view the complete list of faults or the list of ECUs
with at least one fault stored in memory.
The “ Faults By ECUs ” tab. Click on a ECU to
view it’s faults.
Figure 40.
Faults by ECUs
The “ Show All Faults ” tab will show all faults
Figure 41.
Show All Faults
Buttons :
or*
or
*
*Apple or Android
Definition :
This button will export the list of faults.
When this button is pressed, the IIDTool will scan ECUs (“refresh”).
This button clears all faults
This button will clear faults from one ECU only.
