132
133
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
Check number of keys programed
This routine will indicate how many keys are programed on a specific vehicle.
Usage
This function is useful to prevent vehicle theft. For example, if one leaves the vehicle at a detailer, user
can verify if someone programed a new key for malicious usage afterwards. The function will return
two results, the number of programed key(s) currently in the vehicle vicinity and the total number of
key(s) programed.
4.7.19 HCMB Rear View Mirror (L405 and L494 2014-2015)
IPMA Rear View Mirror (L405 and L494 2016 to 2019, L462 up to 2019)
Calibration (2016, new unit only)
This routine is used when this ECU is replaced with a brand new one. This is not required with installing
or retrofitting a used unit.
Camera Calibration Instructions
Please note : During the following application, a 3 - 5 minute drive cycle will be required in order to
successfully calibrate the forward-looking camera
The following screen will present you with a list of instructions crucial to the running of the calibration
routine during the drive cycle, therefore it is very important that you have read and understood them
before continuing with the application.
The following routine will calibrate the forward-looking camera during a drive cycle of 3 - 5 minutes.
This time may increase if the instructions cannot be followed correctly.
Please ensure you read and understand the instructions below :
Vehicle must exceed a minimum speed of 60kph (40mph) in order for the calibration routine to begin.
Vehicle must uphold a speed of 30kph (20mph) or above in order for the calibration routine to complete.
If the speed drops below 30kph (20mph), the calibration routine will pause, and only continue once
60kph (40mph) is again exceeded.
The routine will remain active even over an ignition cycle, in which case the calibration will start from
the beginning.
The calibration routine will not stop until results from the module itself are received.
