Ganz PIXELPRO SERIES, Инструкция по интерфейсу

Страница: 48 / 111

Printed Documentation
40
Smoke Detection
Enable the smoke detection filter by checking the Smoke Detection box in the properties
inspector. If smoke is detected inside the corresponding detection zone alerts are raised in
the alarm log window. The Time setting specifies how long smoke should be detected for,
before the smoke detected event is raised.
WARNING
The smoke detection filter does not comply with any detection standards and should not
be used as a safety device. It should be installed in addition to certified safety devices and
used only to supply additional information.
Diagnostic Data
In order to evaluate the performance of the smoke detection and troubleshoot issues in
challenging circumstances, it's possible to enable the display of smoke blobs. The blobs show
the underlying pixels detected as potentially being smoke by the algorithm. Note that the
blobs must be enabled to be transmitted in the metadata on the
advanced settings page for
them to visible on the annotation overlay.
Blobs that are potentially detected as smoke are displayed in white.