Q.uick Start Guide
Q.brixx
43
Gantner Instruments Inc.
USA | China | Singapore | India | Austria | Germany | France | Sweden
1550 Hotel Circle N ∙ Suite 180 ∙ San Diego CA ∙ 92108 ∙ T +1 888 ∙ 512 ∙ 5788
[email protected]
www.gantner-instruments.com
UART Configuration
It is possible to configure the UARTs on a controller (2 x on Q.gate and 4 x on
Q.station/Q.pac). These settings can be found by double-clicking on the controller and
navigating to Slave interface. The most important setting to consider is baud rate,
which can be configured up to 24M. When the sample rate of the controller is reduced,
it might be necessary to reduce the baud rate also.
Q.station:
Q.gate:
The 2
nd
UART of a Q.gate can be configured to use the Modbus protocol.
