GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Installation
www.gantner.com
HB_GL7p--EN_12
21
3
INSTALLATION
NOTE!
These installation instructions describe how to install the GL7p locker lock. Please read this section carefully
prior to working on the lockers or installing the locks.
Risk of damage or failure to the GL7p
-
Read the information in this section carefully before installing the GL7p.
-
Carefully observe the installation diagrams.
-
Use the correct tools to install the GL7p.
3.1 Target Group
This chapter provides information for technicians who install the GL7p. Experience in mechanical work and basic
electrical knowledge is required. Previous knowledge of the GL7p is not required.
3.2 Test Installation
As the GL7p is suitable for a wide range of installation applications, always perform a test installation including
functional testing of the GL7p in a sample locker from the facility before starting with the mass production of lockers.
Ensure that the latch of the lock slides easily in and out without resistance of the opening in the locker body. Also
test that the GL7p locks and unlocks as required, ideally using a data carrier of the same type to be used with the
locker system to ensure that the data carrier functions as required.
3.3 Replacement after a Burglary Attempt
If a burglary (forced opening) is attempted or occurs at a locker, the entire GL7p including the locker door must be
replaced with a new one.
3.4 Operating Conditions
The GL7p is suitable for locker doors made of metallic and non-metallic materials. The lock may only be used
indoors (see section "8.8 Environmental Conditions
The installation in lockers with metallic doors does not differ from the installation of lockers with non-metallic doors.