G&G CYGG-080, Инструкция по эксплуатации, Страница: 11 / 24

7
SUBSCRIPTIONS
ABOUT THE
AGREEMENT
Declaration of conformity is supplied in separate documentation, delivered with
the cyclone
with a separator.
3 ǀ SAFETY INFORMATION
GENERAL
INFORMATION
It is primarily the responsibility of the operator to ensure their personal safety
when operating the cyclone.
a person designated by the operator. The manufacturer is not responsible for
personal injury or damage to the equipment and environmental damage caused
by not using and operating it in accordance with the instructions for use and
applicable safety regulations.
Cyclone separators are designed in accordance with international standards and
regulations applicable to the manufacture of such equipment. The electrical
components (if any) of the separator shall comply with international regulations
on protection against dangerous contact voltages. All electrical elements
either have the appropriate cover prescribed by the standard or are located in
enclosed spaces whose cover meets the regulations of these standards.
OBLIGATIONS OF
THE OPERATOR
A company that implements cyclone in its technology, or
the operator must ensure the following:
- must clearly define the scope of responsibilities and competencies of the
personnel designated
for installation and connection of the cyclone to the technology
- before putting the cyclone into operation, it must ensure that all those who
come into contact with it can thoroughly familiarise themselves with the
contents of the instructions for use
- must ensure the spatial arrangement of the cyclone so as not to endanger the
operation and activities of personnel operating the surrounding equipment
- must take care to protect the health of the personnel assigned to the
installation or maintenance
cyclone and assign them appropriate personal protective equipment (PPE)
STAFF
REQUIREMENTS
Qualification of personnel for cyclone installation :
Mechanical education - a knowledgeable person, i.e. a person with appropriate
technical education, training and/or experience to recognise and avoid the risks
that may occur when handling and installing a cyclone.
Qualification of personnel for electrical connections:
Education in the electrical field according to the relevant legislation of the
country of the operator, knowledge of the control system technology used.