G&D VisionXS-IP-F-DP-UHR, Инструкция по установке и эксплуатации

Страница: 199 / 232

Configuration
G&D VisionXS-IP-F-DP-UHR · 78
English
Selecting the EDID mode of the KVM extender
EDID information (
Extended Display Identification Data
) of a monitor informs the gra-
phics card of a connected computer about different technical device features. The
information is usually transmitted via Enhanced-DDC (
Enhanced Display Data Chan-
nel
) and without any alteration between KVM extender and computer.
Special GUD profiles are available for some resolutions. The names of these profiles
contain information about the preferred resolution that is sent to the computer's
video card when the profile is used.
As an alternative, you can use the web application Config Panel web application to
read the EDID profile of a monitor. The KVM extender will then transmit it to the
connected computer. For detailed information on this topic, refer to the separate
manual of the Config Panel web application.
How to select the EDID mode of KVM extenders:
NOTE: For initial operation and when connecting another monitor, please follow
the activation sequence recommended on page 18.
OSD
1. Press Ctrl+Num ( default ) to open the OSD.
2. Select the row Target setup and press Enter .
3. Under EDID mode press F8 to select one of the following options:
auto  automatic treatment of EDID data ( default )
user  use of a G&D profile or a profile that has been read out via
web application
4. If the option user has been selected, select the row Assign EDID and press Enter .
Use the arrow keys to select the profile you want the activate and press F8 .
Save your selection by pressing F2 .
5. Press F2 to save your settings.