G&D VisionXS-IP-F-DP-UHR, Инструкция по установке и эксплуатации

Страница: 152 / 232

Establishing a KVM-over-IP™ connection for the first time
31 · G&D VisionXS-IP-F-DP-UHR
Configuring a KVM-over-IP connection of a console
module
You can carry out the required configuration settings directly on the console.
Configuring the network interface
How to configure the network interface:
1. Use the local hotkey Alt + Num to open the OSD of console module.
2. Press F11 to open the Configuration menu.
3. Select the entry Network setup and press Enter .
4. Select the entry Interfaces and press Enter .
5. Enter the following data under Transmission :
6. Press F2 to save your settings.
Configuring the global network settings
Even in complex networks global network settings ensure that the KVM extender is
available from all partial networks.
How to configure global network settings:
1. Use the local hotkey Alt + Num to open the OSD of the console module.
2. Press F11 to open the Configuration menu.
NOTE: Use the local hotkey (default: Alt + Num ) to open the local OSD to configure
the network interface of the console module , or use the remote hotkey (default:
Ctrl + Num ) to open the remote OSD to configure the network interface of the com-
puter module.
The settings of both hotkeys are shown during the starting process of the console
module (see Starting process on page 18).
Operational
mode:
Press F8 to select the operational mode of the interface:

Static: A static IP address is assigned.

DHCP: IP address is obtained from a DHCP server.

Off: switches off network interface.
IP address:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Netmask: Enter the netmask of the network.
The operational mode DHCP does not allow making entries.