G&D VisionXS-IP-F-DP-UHR, Инструкция по установке и эксплуатации

Страница: 149 / 232

Establishing a KVM-over-IP™ connection for the first time
G&D VisionXS-IP-F-DP-UHR · 28
English
Configuring a KVM-over-IP connection of a computer
module
You can carry out the required configuration settings directly on the console.
DEFAULT SETTING OF THE CONSOLE MODULE (CON)
IP address: 172.17.0.11
Netmask 255.255.0.0
Local control port: 18246
Local communication port: 18245
Local data port: 18244
Remote host: 172.17.0.10
Remote control port: 18246
NOTE:
The IP address of the computer module (host) as well as the control port of the
computer module must be specified to establish a KVM-over-IP connection through
the console module.
The configuration of both the
communication ports and the data ports are automati-
cally exchanged between the two modules.
NOTE: Use the local hotkey (default: Alt + Num ) to open the local OSD to configure
the network interface of the console module , or use the remote hotkey (default:
Ctrl + Num ) to open the remote OSD to configure the network interface of the com-
puter module.
The settings of both hotkeys are shown during the starting process of the console
module (see Starting process on page 18).
IMPORTANT: The OSD of the computer module can be opened only if a KVM-over-IP
connection to the computer module is established.
Therefore, you have to change the configuration of the computer module
first .