G&D VisionXS-IP-C-DP-UHR, Сборка, установка и эксплуатация

Страница: 79 / 144

The VisionXS-IP-C-DP-UHR series
G&D VisionXS-IP-C-DP-UHR · 4
English
The VisionXS-IP-C-DP-UHR series
KVM extenders of the VisionXS-IP-C-DP-UHR series consist of a computer module and
a user modules.
Connect the computer to be operated to the computer module ( VisionXS-IP-CPU ). The
remote console is connected to the user module ( VisionXS-IP-CON ).
Both the computer module and the user module are connected via a category 6 (or
better) twisted pair cable.
Signals of keyboard, mouse and DisplayPort™ video of the computer connected are
transmitted using these cables and enable you to operate the computer remotely.
Use as extender or matrix switch modules
You can use the modules as either extender or matrix switch modules:

Extender modules: Configure a KVM-over-IP connection between the computer
and the user module. The configured connection between the modules is restored
each time the modules are restarted.

Matrix switch modules: In combination with the IP matrix switch ControlCenter-IP ,
you can use the modules as end devices of the matrix switch.
In this case, configure a KVM-over-IP connection to the IP matrix switch for the
modules.
In this configuration, the IP matrix switch enables the flexible connection of a user
module to a computer module.
NOTE: You can also use a cable to establish a direct connection between computer
module and user module.
ADVICE: Use the IP-MUX functionality (see page 14 ff.) to make up to 20 computers
available in the OSD via separate computer modules.