G&D VisionXS-F-DP-HR, Инструкция по установке и эксплуатации

Страница: 188 / 224

Configuration
72 · G&D VisionXS-F-DP-HR
Freeze mode
If the cable connection between the computer module and the console module is inter-
rupted during operation, the KVM extender no longer displays an image at the remote
console.
Enable the Freeze mode if you want the last image that has been displayed at the console
module to be available until the connection is re-established.
To highlight an interrupted connection, the last available image can be displayed
with either a coloured frame and/or a Frozen popup and the time passed since the
connection has been interrupted.
How to configure the Freeze mode:
OSD
1. Press Ctrl+Num ( default ) to open the OSD.
2. Select the row Console setup and press Enter .
The following options can be adjusted separately for both video channels, if you use the
optional Transm. Redundancy feature .
3. Under Freeze mode press F8 to select on of the following options:
off  Freeze mode is disabled ( default )
on  Freeze mode is enabled
4. If the Freeze mode is active, press F8 to select one of the options available
under Freeze visualization :
frame  shows a coloured frame when disconnected
OSD  shows Frozen and the time passed since disconnection
frame+OSD  shows a coloured frame ( frame ) and Frozen ( OSD )
With DH variants, you can make these settings for Channel 1 and Channel 2 .
5. Press F2 to save your settings.