G&D TradeSwitch2-USB, Руководство по сборке, установке и эксплуатации

Страница: 53 / 88

Installation
G&D TradeSwitch2-USB · 6
English
Connecting the computers
Line In: I f the audio signals of the computers are to be output over the speakers which are
connected to the KVM switch, use one of the audio connection cables ( Audio-M/M ) to
connect the computer’s Line Out interface to this interface.
Line Out:
If you want to use a microphone or a headset at the console, use one of the
audio connection cables (
Audio-M/M
) to connect this interface to the computer’s
microphone input.
USB 2.0: Use one of the USB connection cables ( USB-AM/BM ) to connect one of the
computer‘s USB interfaces to this interface.
Connecting the TradeSwitch LEDs
LED Out: Connect a TradeSwitch LED ( TS-LED-2 ) to this interface and place the
TradeSwitch LED set on e.g. the monitor.
NOTE:
To connect the (maximum two) computers to the KVM switch, the inter-
faces as shown below are available for each computer.
The label (e.g.
CPU 1 ) assigns the interface to a specific computer and to the corre-
spondent button on the front panel.
Figure 3: Interfaces to connect the computers
Figure 4: Interfaces to connect the TradeSwitch LEDs
Po
wer
CPU 1 CPU 2
USB 2.0 Line In Line Out USB 2.0 Line In Line Out
LED Out 1 LED Out 2
Keyb./Mouse Line In Speaker
Console
CPU 1 CPU 2
USB 2.0 Line In Line Out USB 2.0 Line In Line Out
Keyb./Mouse Line In Speaker
Console
Po
wer
LED Out 1 LED Out 2