G&D DVI-Vision-CAT-AR, Инструкция по установке и эксплуатации

Страница: 92 / 140

Using the Reset button
19 · G&D DVI-Vision-CAT
Using the Reset button
The Reset button is located between the Identification LED and the Power LEDs on
the front panel of the computer module and the user module.
This button enables you to reset the default settings as well as to temporarily deacti-
vate the netfilter rules.
Resetting the default settings
Pressing and holding the button during booting resets the default setting of the module.
1. Switch off the device if in operation.
2. Press and hold the Reset button on the front panel of the device.
3. Keep the button pressed and switch on the device.
4. Release the button as soon as the green Switch LED is fast blinking.
NOTE: As protection against pressing the button accidentally, it is located behind a
drilling in the front panel.
Use a thin, pointed item to press the button.
NOTE: When carrying out this function at the user module, the data is reset on the
local OSD. After this function has been carried out at the computer module, the
default settings of the KVM extender listed on page 21 are reactivated.
NOTE: You can also reset the default settings using the OSD or the
Config Panel
web application (see page 44).
When using the web application to reset the default settings, it is possible to keep the
configuration of the network interfaces.