G&D DVI-Vision-CAT-AR, Инструкция по установке и эксплуатации

Страница: 83 / 140

Installation
G&D DVI-Vision-CAT · 10
English
Installing user modules
The remote console is connected to the DVI-Vision-CAT-CON user module. The com-
puter connected to the computer module can be operated from this console.
Establishing a connection to a local network
Network:
Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse of consoles
Keyb./Mouse: Connect the mouse and/or the keyboard of the console to this interface.
Generic: In the default settings, you can use this interface to connect another USB
input device or a supported display or tablet.
Activate the
generic HID
mode (see
Selecting the USB-HID mode
on page 35) if you want
to connect another USB input device. In this mode, any data of the USB input device
is not altered when transmitted to the computer module.
Mouse: Connect the PS/2 mouse of the console.
Keyb.: Connect the PS/2 keyboard of the console.
NOTE: If desired, connect the network interface to a local network. This enables
you to access the
Config Panel
web application from this network and to send sys-
log messages to this network.
NOTE: Both the keyboard and the mouse of the console can either be PS/2 or USB
devices.
IMPORTANT: If the generic HID mode is active, the OSD cannot be operated by a
keyboard connected to the Generic socket.
Service
Network
Ident.
Main
Red.
Power
Video
K/M
Console
Trans.
System
Status
USB Devices
Main P
ower
RS232
DVI/VGA Out Red. Power
USB 2.0 Devices
Micro In Speaker Transmission
USB 2.0 Trans. Mouse
Keyb.
Generic
Keyb./Mouse