G&D DVI-Vision-CAT-AR, Инструкция по установке и эксплуатации

Страница: 120 / 140

Configuration
47 · G&D DVI-Vision-CAT
Adjusting the transparency of the on-screen display
In the default settings of the KVM switch, the on-screen display covers parts of the
screen content. However, the parts of the screen contents covered by the OSD are
still visible.
You can adjust the transparency level or turn the transparency off.
How to adjust the transparency of the on-screen display:
OSD
1. Press Ctrl+Num (default) to open the on-screen display.
2. Select the row Console setup and press Enter .
3. Select the row Personal Profile and press Enter .
4. Under OSD transparency press F8 to select on of the following options:
high  high transparency of the screen content
average  average transparency of the screen content ( default )
low  low transparency of the screen content
off  screen content is covered
5. Press F2 to save your settings.
Confi
g
Pan
el
1. Click on
KVM Extenders > [All Extenders]
on the directory tree.
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tabs
Remote > Extender system > Personal profile
.
4. Under
OSD transparency
select one of the following options:
high
 high transparency of the screen content
average
 average transparency of the screen content (
default
)
low
 low transparency of the screen content
off
 screen content is covered
5. Click
OK
to save your changes.