G&D DVI-Vision-CAT-AR, Инструкция по установке и эксплуатации

Страница: 112 / 140

Configuration
39 · G&D DVI-Vision-CAT
Support of special keyboards
The KVM extender supports special functions of some special keyboards.
Enable the support of such keys if you want to use them at the console.
How to enable or disable the support for special keyboards:
Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe “|” or the arrow keys do not
work as expected.
OSD
1. Press Ctrl+Num (default) to open the on-screen display.
2. Select the row Console setup and press Enter if you want to adjust the support
of a special keyboard for the remote console (at the CON module).
Select the row Local console setup and press Enter if you want to adjust the
support of a special keyboard for the local console (at the CPU module).
3. Under Enh. keyboard press F8 to select one of the following options:
no  disables support of special keyboards
PixelPower C  enables support of keyboard PixelPower Blue
SKIDATA1  enables support of keyboard SKIDATA1
4. Press F2 to save your settings.
Config
Pa
n
el
1. Click on
KVM Extenders > [All Extenders]
on the directory tree.
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
Local
if you want to adjust the support of a special key-
board for the local console (at the
CPU
module).
Click on the tab
Remote > General
if you want to adjust the support of a spe-
cial keyboard for the remote console (at the
CON
module).
4. Under
PS/2 keyboard type
select one of the following options:
default
 disables support of special keyboards
PixelPower Blue
 enables support of keyboard
PixelPower Blue
SKIDATA1
 enables support of keyboard
SKIDATA1
5. Click
OK
to save your changes.