G&D DP-Vision-CAT Series, Инструкция по установке и эксплуатации

Страница: 125 / 168

Configuration
38 · G&D DP-Vision-CAT
Related topics:
 Operating the KVM extender exclusively on page 20

Changing the video mode of consoles on page 40
Adjusting the operating mode of the RS232 interface
In the default setting of the extender, you can connect any RS232-compatible device
to the optional RS232 interface of the console module. The RS232 data stream is
transmitted unchanged to the computer module.
Fro transmitting RS422 signals, you can use two G&D RS232-422 adapters . Each of the
adapters converts the RS232 interface of the console module and the computer mod-
ule into RS422 interfaces.
Conf
ig P
anel
1. In the menu, click on KVM extender .
2. Click on the computer module (CPU) you want to configure and then click
on Configuration .
3. Click on the tab General .
4. Click on the tab CPU if you want to configure the access to the local work-
station (on the CPU module).
Click on the tab CON if you want to configure the access to the remote work-
station (on the CON module).
5. In the field Permanent access mode , select one of the following options:
Enabled  right for exclusive access is granted ( default )
Disabled  right for exclusive access is denied
6. Click on Save .
IMPORTANT: If you want to transmit RS422 signals, in addition to using adapters,
you also need to change the operating mode of the RS232 interfaces of both the
console and the computer module.