Figure 19. Battery mode
6.5.
Communications mode (Comm)
Figure 20. Communication mode
RS protocol
This parameter allows protocol selection for remote communications. The
available options are listed below.
Figure 21. RS protocol
Mode
There are three user input modes to the SPCe. They are changed by
selecting Mode on the Comm menu. Select the type of communication for
the controller.
▪
Local: The controller only accepts change commands made via the
keypad. The controller will accept read only commands via serial/
Ethernet. It will not, however, accept write/change commands via serial/
Ethernet.
▪
Remote: The controller will accept all serial and Ethernet commands.
When remote mode is activated, the keypad is locked. To unlock the
keypad, press and hold down arrow key. Note, when keypad is unlocked,
the communication mode is set to full. To lock the keypad, press and hold
down arrow key or set communication mode to remote. Message
“Keypad locked” is shown on the screen.
▪
Full: The controller will accept all commands from the keypad and serial/
Ethernet.
04/2021 - ©Gamma
Page 23
900026_F
900026_F - Display menu
