4.
Installation
▪
The SPCe can be mounted in a standard 19 in. (48.3 cm) rack or used as a
free-standing unit. Optional 19-in. Rack Adapter Kit (part 310057) and
Half-Rack Adapter Kit (part 360242) are available.
▪
When installing, make sure the rear power cord is accessible.
▪
Maintain a 2.52 in. (64 mm) clearance behind controllers for cable bend
radius and proper airflow.
▪
Maintain a .125 in. (3 mm) gap between vertically mounted controllers.
This gap is designed in the rack mount kit, and they can be mounted
directly above or below each other.
▪
Position the control so that the power plug can be reached to disconnect
power.
CAUTION:
This equipment uses a high voltage, detachable power supply cord. Do not
replace with inadequately rated supply cords.
CAUTION:
Remove all metal jewellery prior to working with any potential electrical
hazards.
4.1.
Required items
You will need the following items to install the controller:
1.
A 3-wire, detachable, universal input power cable that connects to the
24 V power supply (both included for most part numbers).
2.
A high voltage (HV) cable for each pump (ordered separately).
3.
A safety ground cable for each pump (ordered separately).
4.2.
Installation procedure
1.
Place the controller in its location and secure as necessary.
2.
Connect the safety ground cable to the pump and the safety ground stud
at the SPCe rear panel.
3.
Connect the high voltage cable to the ion pump and the high voltage
connector on the SPCe rear panel (J501).
4.
If you have the optional SAFECONN feature, an additional connector is
part of the HV cable. Connect it to the SAFECONN connector (J401).
5.
Verify input voltage requirements, and then connect the detachable
universal input power adapter cable to the input power receptacle on the
24 V power supply. Connect the 24 V d.c. supply to the SPCe.
6.
Connect the power adapter mains cable to A/C power source.
04/2021 - ©Gamma
Page 13
900026_F
900026_F - Installation
