4.
To turn supply 1 on (or off), press the top
Display Select
key to toggle to the desired
value. To turn supply 2 on (or off), press the bottom
Display Select
key to toggle to
the desired value.
5.
Press the
ENTER
key.
NOTE: If you turn a supply ON and have not set the pump size for that supply, the display
automatically goes to PUMP SIZE menu to allow you to set the value.
When you are finished
The
High Voltage Enable
indicator on the front panel lights when high voltage is applied for the
corresponding supply.
TSP
When you press the
TSP
(
←
) key, TSP SETUP provides:
•
Four operation modes
•
Three CONFIG (setup parameters)
Use the
Menu
key to cycle through the following options.
Operation Modes
TIMED
TIMED is the main operating mode. You can set the amount of time between cycles, duration
of each fire, number of cycles, and minimum pressure value for operation.
CONTINUOUS
CONTINUOUS turns the TSP on and leaves it on. Use caution when selecting this operating
mode, it could blow a fuse in the Remote TSP/NEG Control unit.
ALL STOP
OFF mode turns the TSP off. It is the default operating mode when the MPC powers up.
DEGAS
DEGAS is a maintenance tool. If your filaments are new or have been brought up to air, the
DEGAS operating mode conditions them.
CONFIG (Setup Parameters)
SUBLEVEL
With this parameter, you can select current or power and specify its value.
FILAMENT
Contains a submenu of options for filament operation including: SET MODE, SET ACTIVE,
and CLEAR DATA which control the filament advance mode, active filament (1-4), and the
filament history log reset, respectively.
DATE/TIME
Sets the date and time on the TSP controller board from the MPC date and time.
Operation Modes:
TIMED
TIMED is the main operating mode. This mode controls the amount of time between cycles, the
number of cycles, and the minimum pressure value. To operate in TIMED mode, press the
TSP
(
←
) key. It is the first display in TSP SETUP.
1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
Supply 2
1.
Before enabling TIMED mode, make sure these parameters are setup.
Digitel MPC Manual
Page 25 of 72
