1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
Supply 2
6.
When the display asks you to CONFIRM, press
ENTER
to save your bake
parameters or
ESC
to exit without saving changes.
After you have finished
Once the delayed bake is enabled, the display flashes "BAKE OK" for 1 second every 5 seconds.
Once the bake is started, the display flashes "BAKE nn.nH" where nn.nH indicates how many
hours are left in the bake. When pressure is exceeded, the bake is suspended.
How long have the heaters been on? Once your bake has started, the actual on time for the
heaters is logged and can be retrieved at any time. To do this,
1.
press the
Bake
key,
2.
select TIME LOG with the
Display Select
key, and
3.
press
ENTER
. The bottom display shows the actual on time for the heaters.
To cancel the bake
Once your bake has been enabled, if you want to cancel it,
1.
press the
Bake
key,
2.
press the
Display Select
key to toggle to DISABLE,
3.
press
ENTER
, and press
ENTER
again to confirm.
High Voltage Operate
If the MPC is in manual restart,
High Voltage Operate
(the
9
key) allows you to enable high
voltage to one or both supplies.
To apply high voltage
To apply high voltage, the following steps must be performed:
Note: If the DIGITEL MPC is in POWER-LOSS RESTART mode, do not perform Steps 3, 4, and
5.
1.
Ensure that the high voltage cable is connected to both the pump and the MPC. Press
the front panel main
Power
switch to 1 (1=ON).
2.
If the MPC is in manual restart, press
9
to select
High Voltage Operate
. The top
display shows the state of HV 1 (ON or OFF), and the bottom display shows the state
of HV 2.
3.
Ensure that the pump size (refer to Section 3, Setting Pump Size) has been specified.
1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
Supply 2
Display
Select
Display
Select
Options:
- HV1 OFF
- HV1 ON
- HV2 OFF
- HV2 ON
HV 1 OFF
Top key toggles between
ON and OFF for Supply 1.
Bottom key toggles between
ON and OFF for Supply 2.
Digitel MPC Manual
Page 24 of 72